Pontiac : Firebird 1968 Pontiac Firebird 455 Big Block Ready for paint

You are bidding on a 1968 Pontiac Firebird.  The car originaly had a 6 cylinder.  I bouhgt a 455 block with heads and crank.  Also a 400 transmission comes with it that is rebuilt and ready.  The 455 will need to be rebuilt.   Also the Engine is a 4 bolt main (hard to find).   I have taken a picture of all the parts I have bought for the car.  I have spent over $6000 in parts and labor so far.  The car has new floor pans and new quarters.  The trank pan looks good.  The front sub frame was pulled out, cleaned and primed.

PARTS:

2 new quarters  which are installed already

2 new floor pan sections which are installed already

2 new fenders

2 new inner fenders

1 new core support

1 new fiberglass hood

1 new rear glass

1 new interior kit       no door panels

1 new dash pad

1 new head linner

1 new pachage tray

2 used bucket seats that I had to buy

2 new exterior door handles

2 new interior door handles

New rubber for the whole car

New felts for around the window

New chrome drip rail moldings

New chrome fender trim

New chrome step plates

1 New spoiler

New body bushing Kit

Used center console

New heater core and blower motor

2 New Lower fender drop offs

1 Full disk brake kit for the front comes with booster and valve

New front coil springs

2 new hood hinges no spings

New wire harness

New carpet kit

There are some parts that will be needed.  The ones that I can think of are Trunk lid, back seats, door panels and more.  Please ask for what you are looking for and I will tell you if I have it or not.  The car is ready for paint.  I have primed and blocked the car 3 times and it need its final block then sealed and painted.  Fenders and hood are not ready for paint they are brand new.  Maybe a little blocking and prime and they will be ready.  The title is open and ready for you to pick it up.  Just looking for a good home.  I just dont have the time to finish.  Any questions please ask.  Thanks again Mike