Geo Metro Recalls
Vehicle manufacturers issue official Geo Metro recall notices to inform car owners of problems and/or defects that have been brought to the manufacturer's attention. An automotive recall requires the manufacturer to send an official notice to owners of the vehicles found to be defective once the NHTSA deems the problem to be wide spread and an official Geo Metro recall. View listings of Geo Metro recalls from NHTSA below with full details, vehicles affected, date reported, and more.
|
|
 |
Used 1997 Geo Metro Recalls
Components: POWER TRAIN:AUTOMATIC TRANSMISSION:PARK/NEUTRAL...
Cars Affected: 32,903
Summary:
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH AN AUTOMATIC TRANSAXLE. THE SHIFT LEVER APPEARS TO BE IN "PARK," BUT CAN EASILY BE MOVED FROM THE "PARK" POSITION WITHOUT THE USE OF THE KEY, TRANSAXLE LEVER DETENT BUTTON, OR DEPRESSING THE BRAKE.
Consequences:
IF THE SHIFT LEVER WERE TO COME OUT OF "PARK" WHILE THE VEHICLE IS PARKED ON A NON-LEVEL SURFACE, THE VEHICLE COULD ROLL INCREASING THE RISK OF A CRASH.
Remedy:
DEALERS WILL REPLACE THE SHIFTER ASSEMBLY. UNTIL THE VEHICLE IS SERVICED, OWNERS ARE ADVISED WHEN SHIFTING TO "PARK," ALWAYS APPLY THE PARK BRAKE BEFORE RELEASING THE SERVICE BRAKE.
|
|
|
Used 1995 Geo Metro Recalls
Components: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS...
Cars Affected: 435
Summary:
THE REAR BRAKE DRUMS WERE NOT CORRECTLY MACHINED. AS THE VEHICLE IS DRIVEN, LOSS OF WHEEL CLAMP LOAD CAN RESULT FROM THIS CONDITION. ONCE CLAMP LOAD IS LOST, ALL TIRE LOADS ARE DIRECTLY TAKEN BY THE WHEEL STUDS. THIS LOADING CAN CAUSE FATIGUE FAILURE OF THE WHEEL STUDS.
Consequences:
IF THIS OCCURS, A WHEEL COULD SEPARATE FROM THE VEHICLE, AND A CRASH COULD OCCUR WITHOUT PRIOR WARNING.
Remedy:
REPLACE REAR BRAKE DRUMS.
|
|
|
Used 1993 Geo Metro Recalls
Components: LATCHES/LOCKS/LINKAGES:HOOD:LATCH
Cars Affected: 356,097
Summary:
MISLOCATED ATTACHING SPOT WELDS OF THE HOOD STRIKER ASSEMBLY CAUSE CRACKS TO START ON THE HOOD INNER PANEL. IF CRACKS OCCUR, THE HOOD STRIKER ASSEMBLY MAY NOT PROPERLY ENGAGE THE HOOD LATCH WHEN THE HOOD IS CLOSED.
Consequences:
AN IMPROPERLY ENGAGED HOOD LATCH MAY RESULT IN A HOODFLY-UP WHILE THE VEHICLE IS IN MOTION. THIS WOULD OBSTRUCT THE DRIVER'S VIEWAND COULD CAUSE A VEHICLE CRASH.
Remedy:
GM DEALERS WILL (A) INSTALL TWO BOLTS AND NUTS TO SECURE THE STRIKER ASSEMBLY TO THE HOOD INNER PANEL, AND (B) ENSURE THAT THE HOOD LATCH ASSEMBLY FASTENERS ARE PROPERLY TIGHTENED.
|
|
|
Used 1992 Geo Metro Recalls
Components: LATCHES/LOCKS/LINKAGES:HOOD:LATCH
Cars Affected: 356,097
Summary:
MISLOCATED ATTACHING SPOT WELDS OF THE HOOD STRIKER ASSEMBLY CAUSE CRACKS TO START ON THE HOOD INNER PANEL. IF CRACKS OCCUR, THE HOOD STRIKER ASSEMBLY MAY NOT PROPERLY ENGAGE THE HOOD LATCH WHEN THE HOOD IS CLOSED.
Consequences:
AN IMPROPERLY ENGAGED HOOD LATCH MAY RESULT IN A HOODFLY-UP WHILE THE VEHICLE IS IN MOTION. THIS WOULD OBSTRUCT THE DRIVER'S VIEWAND COULD CAUSE A VEHICLE CRASH.
Remedy:
GM DEALERS WILL (A) INSTALL TWO BOLTS AND NUTS TO SECURE THE STRIKER ASSEMBLY TO THE HOOD INNER PANEL, AND (B) ENSURE THAT THE HOOD LATCH ASSEMBLY FASTENERS ARE PROPERLY TIGHTENED.
|
|
|
Used 1991 Geo Metro Recalls
Components: SEAT BELTS:FRONT:BUCKLE ASSEMBLY
Cars Affected: 466,902
Summary:
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequences:
THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy:
OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
Components: LATCHES/LOCKS/LINKAGES:HOOD:LATCH
Cars Affected: 356,097
Summary:
MISLOCATED ATTACHING SPOT WELDS OF THE HOOD STRIKER ASSEMBLY CAUSE CRACKS TO START ON THE HOOD INNER PANEL. IF CRACKS OCCUR, THE HOOD STRIKER ASSEMBLY MAY NOT PROPERLY ENGAGE THE HOOD LATCH WHEN THE HOOD IS CLOSED.
Consequences:
AN IMPROPERLY ENGAGED HOOD LATCH MAY RESULT IN A HOODFLY-UP WHILE THE VEHICLE IS IN MOTION. THIS WOULD OBSTRUCT THE DRIVER'S VIEWAND COULD CAUSE A VEHICLE CRASH.
Remedy:
GM DEALERS WILL (A) INSTALL TWO BOLTS AND NUTS TO SECURE THE STRIKER ASSEMBLY TO THE HOOD INNER PANEL, AND (B) ENSURE THAT THE HOOD LATCH ASSEMBLY FASTENERS ARE PROPERLY TIGHTENED.
|
|
|
Used 1990 Geo Metro Recalls
Components: SEAT BELTS:FRONT:BUCKLE ASSEMBLY
Cars Affected: 466,902
Summary:
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequences:
THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy:
OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
Components: LATCHES/LOCKS/LINKAGES:HOOD:LATCH
Cars Affected: 356,097
Summary:
MISLOCATED ATTACHING SPOT WELDS OF THE HOOD STRIKER ASSEMBLY CAUSE CRACKS TO START ON THE HOOD INNER PANEL. IF CRACKS OCCUR, THE HOOD STRIKER ASSEMBLY MAY NOT PROPERLY ENGAGE THE HOOD LATCH WHEN THE HOOD IS CLOSED.
Consequences:
AN IMPROPERLY ENGAGED HOOD LATCH MAY RESULT IN A HOODFLY-UP WHILE THE VEHICLE IS IN MOTION. THIS WOULD OBSTRUCT THE DRIVER'S VIEWAND COULD CAUSE A VEHICLE CRASH.
Remedy:
GM DEALERS WILL (A) INSTALL TWO BOLTS AND NUTS TO SECURE THE STRIKER ASSEMBLY TO THE HOOD INNER PANEL, AND (B) ENSURE THAT THE HOOD LATCH ASSEMBLY FASTENERS ARE PROPERLY TIGHTENED.
|
|
|
Used 1989 Geo Metro Recalls
Components: SEAT BELTS:FRONT:BUCKLE ASSEMBLY
Cars Affected: 466,902
Summary:
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequences:
THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy:
OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
Components: LATCHES/LOCKS/LINKAGES:HOOD:LATCH
Cars Affected: 356,097
Summary:
MISLOCATED ATTACHING SPOT WELDS OF THE HOOD STRIKER ASSEMBLY CAUSE CRACKS TO START ON THE HOOD INNER PANEL. IF CRACKS OCCUR, THE HOOD STRIKER ASSEMBLY MAY NOT PROPERLY ENGAGE THE HOOD LATCH WHEN THE HOOD IS CLOSED.
Consequences:
AN IMPROPERLY ENGAGED HOOD LATCH MAY RESULT IN A HOODFLY-UP WHILE THE VEHICLE IS IN MOTION. THIS WOULD OBSTRUCT THE DRIVER'S VIEWAND COULD CAUSE A VEHICLE CRASH.
Remedy:
GM DEALERS WILL (A) INSTALL TWO BOLTS AND NUTS TO SECURE THE STRIKER ASSEMBLY TO THE HOOD INNER PANEL, AND (B) ENSURE THAT THE HOOD LATCH ASSEMBLY FASTENERS ARE PROPERLY TIGHTENED.
|
|
|
|
|
