Volkswagen Jetta III Recalls
Vehicle manufacturers issue official Volkswagen Jetta III recall notices to inform car owners of problems and/or defects that have been brought to the manufacturer's attention. An automotive recall requires the manufacturer to send an official notice to owners of the vehicles found to be defective once the NHTSA deems the problem to be wide spread and an official Volkswagen Jetta III recall. View listings of Volkswagen Jetta III recalls from NHTSA below with full details, vehicles affected, date reported, and more.
|
|
 |
Used 1995 Volkswagen Jetta III Recalls
Components: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS...
Cars Affected: 153,000
Summary:
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR BRAKE LINE ON THE PASSENGER SIDE WAS ROUTED TOO CLOSE TO THE CORNER OF THE FUEL TANK. THE LINE COULD BE DAMAGED BY CHAFING AGAINST THE FUEL TANK.
Consequences:
REPEATED CHAFING COULD EVENTUALLY RESULT IN A LEAKING BRAKE LINE CAUSING DIMINISHED BRAKING IN ONE BRAKE CIRCUIT INCREASING THE VEHICLE'S STOPPING DISTANCE.
Remedy:
DEALERS WILL INSPECT THE BRAKE LINE AND REPLACE ANY DAMAGED LINES.
Components: LATCHES/LOCKS/LINKAGES:HOOD:LATCH
Cars Affected: 238,000
Summary:
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE BOLTS SECURING THE FRONT HOOD LATCH CAN LOOSEN OVER TIME. THE LATCH WOULD MOVE CAUSING DISENGAGEMENT OF THE HOOD STRIKER FROM THE LATCH.
Consequences:
UNEXPECTED OPENING OF THE HOOD COULD OCCUR OBSTRUCTING THE DRIVER'S VIEW OF THE ROAD WHILE DRIVING, INCREASING THE RISK OF A CRASH.
Remedy:
DEALERS WILL INSPECT THE HOOD LATCH AND SECURING BOLTS AND REPLACE THEM IF NECESSARY.
Components: ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN
Cars Affected: 34,000
Summary:
IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY.
Consequences:
A WORN AND NOISY FAN MOTOR SHAFT CAN SEIZE RENDERINGTHE FAN MOTOR INOPERATIVE, EVENTUALLY CAUSING THE ENGINE TO OVERHEAT AND STALL. A STALLED VEHICLE IN TRAFFIC CAN INCREASE THE POTENTIAL FOR A VEHICLE ACCIDENT.
Remedy:
DEALERS WILL REPLACE THE COMPLETE COOLING FAN ASSEMBLY ON VEHICLE HAVING THE POTENTIAL SHAFT MATERIAL PROBLEM. DEALERS WILL INSTALL A NEW FAN BLADE INCLUDING A NEW LOCK NUT ON VEHICLE WITH LOOSE FAN BLADE LOCK NUTS.
Components: VEHICLE SPEED CONTROL
Cars Affected: 79
Summary:
WHEN INSTALLED IN THE VEHICLES, A TIE WRAP IS USED TO GUIDE THE CRUISE CONTROL CABLE IN THE ENGINE COMPARTMENT. SOME TIE WRAPS HAVE BEEN INSTALLED WITH A LARGE LOOP OPENING IMPROPERLY GUIDING THE CABLE WHICH COULD PREVENT THE THROTTLE FROM RETURNING TO ITS FULL IDLE POSITION.
Consequences:
THE ENGINE SPEED MAY NOT RETURN TO IDLE INCREASING THEPOTENTIAL FOR A VEHICLE COLLISION.
Remedy:
DEALERS WILL REMOVE THE CRUISE CONTROL TIE WRAP AND INSTALL A NEWLY DESIGNED GUIDE.
Components: EQUIPMENT:MECHANICAL:JACKS
Cars Affected: 104,000
Summary:
THE JACKS SUPPLIED WITH THESE VEHICLES WERE ASSEMBLED WITH AN IMPROPERLY MACHINED SPINDLE, SO THAT A SHARP RIDGE ON THE EDGE OF SPINDLE'S THREAD WOULD HAVE REMAINED.
Consequences:
THIS RIDGE CAN DAMAGE THE INSIDE THREAD OF THE JACK'S SCISSOR SHOE WHEN THE JACK IS USED TO LIFT THE VEHICLE. THE JACK COULD COLLAPSE WITH THE POSSIBILITY THAT A PERSON STANDING CLOSE TO THE VEHICLE COULD BE INJURED.
Remedy:
OWNERS WILL BE PROVIDED WITH A NEW JACK.
|
|
|
Used 1994 Volkswagen Jetta III Recalls
Components: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS...
Cars Affected: 153,000
Summary:
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR BRAKE LINE ON THE PASSENGER SIDE WAS ROUTED TOO CLOSE TO THE CORNER OF THE FUEL TANK. THE LINE COULD BE DAMAGED BY CHAFING AGAINST THE FUEL TANK.
Consequences:
REPEATED CHAFING COULD EVENTUALLY RESULT IN A LEAKING BRAKE LINE CAUSING DIMINISHED BRAKING IN ONE BRAKE CIRCUIT INCREASING THE VEHICLE'S STOPPING DISTANCE.
Remedy:
DEALERS WILL INSPECT THE BRAKE LINE AND REPLACE ANY DAMAGED LINES.
Components: LATCHES/LOCKS/LINKAGES:HOOD:LATCH
Cars Affected: 238,000
Summary:
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE BOLTS SECURING THE FRONT HOOD LATCH CAN LOOSEN OVER TIME. THE LATCH WOULD MOVE CAUSING DISENGAGEMENT OF THE HOOD STRIKER FROM THE LATCH.
Consequences:
UNEXPECTED OPENING OF THE HOOD COULD OCCUR OBSTRUCTING THE DRIVER'S VIEW OF THE ROAD WHILE DRIVING, INCREASING THE RISK OF A CRASH.
Remedy:
DEALERS WILL INSPECT THE HOOD LATCH AND SECURING BOLTS AND REPLACE THEM IF NECESSARY.
Components: VISIBILITY:POWER WINDOW DEVICES AND CONTROLS
Cars Affected: 1,100
Summary:
THE SHEET METAL PANELS OF BOTH REAR DOORS HAVE OPENINGS FOR THE ROUTING OF THE ELECTRICAL WINDOW REGULATOR WIRING. THE PANEL OPENINGS HAVE SHARP EDGES THAT CAN DAMAGE THE INSULATION OF THE WIRING HARNESS.
Consequences:
AN ELECTRICAL SHORT IN THE WIRING CAN OCCUR RESULTING IN A POSSIBLE FIRE.
Remedy:
DEALERS WILL INSTALL A PROTECTIVE EDGE COVER IN BOTH REAR DOOR INNER PANEL OPENINGS.
Components: ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN
Cars Affected: 34,000
Summary:
IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY.
Consequences:
A WORN AND NOISY FAN MOTOR SHAFT CAN SEIZE RENDERINGTHE FAN MOTOR INOPERATIVE, EVENTUALLY CAUSING THE ENGINE TO OVERHEAT AND STALL. A STALLED VEHICLE IN TRAFFIC CAN INCREASE THE POTENTIAL FOR A VEHICLE ACCIDENT.
Remedy:
DEALERS WILL REPLACE THE COMPLETE COOLING FAN ASSEMBLY ON VEHICLE HAVING THE POTENTIAL SHAFT MATERIAL PROBLEM. DEALERS WILL INSTALL A NEW FAN BLADE INCLUDING A NEW LOCK NUT ON VEHICLE WITH LOOSE FAN BLADE LOCK NUTS.
Components: VEHICLE SPEED CONTROL
Cars Affected: 79
Summary:
WHEN INSTALLED IN THE VEHICLES, A TIE WRAP IS USED TO GUIDE THE CRUISE CONTROL CABLE IN THE ENGINE COMPARTMENT. SOME TIE WRAPS HAVE BEEN INSTALLED WITH A LARGE LOOP OPENING IMPROPERLY GUIDING THE CABLE WHICH COULD PREVENT THE THROTTLE FROM RETURNING TO ITS FULL IDLE POSITION.
Consequences:
THE ENGINE SPEED MAY NOT RETURN TO IDLE INCREASING THEPOTENTIAL FOR A VEHICLE COLLISION.
Remedy:
DEALERS WILL REMOVE THE CRUISE CONTROL TIE WRAP AND INSTALL A NEWLY DESIGNED GUIDE.
Components: EQUIPMENT:MECHANICAL:JACKS
Cars Affected: 104,000
Summary:
THE JACKS SUPPLIED WITH THESE VEHICLES WERE ASSEMBLED WITH AN IMPROPERLY MACHINED SPINDLE, SO THAT A SHARP RIDGE ON THE EDGE OF SPINDLE'S THREAD WOULD HAVE REMAINED.
Consequences:
THIS RIDGE CAN DAMAGE THE INSIDE THREAD OF THE JACK'S SCISSOR SHOE WHEN THE JACK IS USED TO LIFT THE VEHICLE. THE JACK COULD COLLAPSE WITH THE POSSIBILITY THAT A PERSON STANDING CLOSE TO THE VEHICLE COULD BE INJURED.
Remedy:
OWNERS WILL BE PROVIDED WITH A NEW JACK.
|
|
|
Used 1993 Volkswagen Jetta III Recalls
Components: SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS...
Cars Affected: 153,000
Summary:
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR BRAKE LINE ON THE PASSENGER SIDE WAS ROUTED TOO CLOSE TO THE CORNER OF THE FUEL TANK. THE LINE COULD BE DAMAGED BY CHAFING AGAINST THE FUEL TANK.
Consequences:
REPEATED CHAFING COULD EVENTUALLY RESULT IN A LEAKING BRAKE LINE CAUSING DIMINISHED BRAKING IN ONE BRAKE CIRCUIT INCREASING THE VEHICLE'S STOPPING DISTANCE.
Remedy:
DEALERS WILL INSPECT THE BRAKE LINE AND REPLACE ANY DAMAGED LINES.
Components: LATCHES/LOCKS/LINKAGES:HOOD:LATCH
Cars Affected: 238,000
Summary:
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE BOLTS SECURING THE FRONT HOOD LATCH CAN LOOSEN OVER TIME. THE LATCH WOULD MOVE CAUSING DISENGAGEMENT OF THE HOOD STRIKER FROM THE LATCH.
Consequences:
UNEXPECTED OPENING OF THE HOOD COULD OCCUR OBSTRUCTING THE DRIVER'S VIEW OF THE ROAD WHILE DRIVING, INCREASING THE RISK OF A CRASH.
Remedy:
DEALERS WILL INSPECT THE HOOD LATCH AND SECURING BOLTS AND REPLACE THEM IF NECESSARY.
Components: ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN
Cars Affected: 34,000
Summary:
IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY.
Consequences:
A WORN AND NOISY FAN MOTOR SHAFT CAN SEIZE RENDERINGTHE FAN MOTOR INOPERATIVE, EVENTUALLY CAUSING THE ENGINE TO OVERHEAT AND STALL. A STALLED VEHICLE IN TRAFFIC CAN INCREASE THE POTENTIAL FOR A VEHICLE ACCIDENT.
Remedy:
DEALERS WILL REPLACE THE COMPLETE COOLING FAN ASSEMBLY ON VEHICLE HAVING THE POTENTIAL SHAFT MATERIAL PROBLEM. DEALERS WILL INSTALL A NEW FAN BLADE INCLUDING A NEW LOCK NUT ON VEHICLE WITH LOOSE FAN BLADE LOCK NUTS.
Components: VEHICLE SPEED CONTROL
Cars Affected: 79
Summary:
WHEN INSTALLED IN THE VEHICLES, A TIE WRAP IS USED TO GUIDE THE CRUISE CONTROL CABLE IN THE ENGINE COMPARTMENT. SOME TIE WRAPS HAVE BEEN INSTALLED WITH A LARGE LOOP OPENING IMPROPERLY GUIDING THE CABLE WHICH COULD PREVENT THE THROTTLE FROM RETURNING TO ITS FULL IDLE POSITION.
Consequences:
THE ENGINE SPEED MAY NOT RETURN TO IDLE INCREASING THEPOTENTIAL FOR A VEHICLE COLLISION.
Remedy:
DEALERS WILL REMOVE THE CRUISE CONTROL TIE WRAP AND INSTALL A NEWLY DESIGNED GUIDE.
Components: EQUIPMENT:MECHANICAL:JACKS
Cars Affected: 104,000
Summary:
THE JACKS SUPPLIED WITH THESE VEHICLES WERE ASSEMBLED WITH AN IMPROPERLY MACHINED SPINDLE, SO THAT A SHARP RIDGE ON THE EDGE OF SPINDLE'S THREAD WOULD HAVE REMAINED.
Consequences:
THIS RIDGE CAN DAMAGE THE INSIDE THREAD OF THE JACK'S SCISSOR SHOE WHEN THE JACK IS USED TO LIFT THE VEHICLE. THE JACK COULD COLLAPSE WITH THE POSSIBILITY THAT A PERSON STANDING CLOSE TO THE VEHICLE COULD BE INJURED.
Remedy:
OWNERS WILL BE PROVIDED WITH A NEW JACK.
|
|
|
|
